Supra LoRad 6 way Mains Distribution Block Mark 3
New investment has seen an updating of the very successful MD06
Mk 2 range of Mains Distribution Blocks, which are now being made
in the factory in Sweden (instead of using a 3rd party contractor
to assemble them).
For UK:
Safety approval has been gained, and we now have UK versions approved
for use within the UK and we have versions featuring from 2 outlets
upto 11 outlets.
We can offer Custom (Unfiltered) versions (for certain brands
of "fussy" amplifiers), Non-Intrusive Filtered (NIF)
versions, (if RF noise is a problem) and Surge-Protected (SP)
versions are available (for those suffering from "clicks"
through their systems as a result of old thermostats causing interference.
Versions for Europe/US/Australia:
The new range is also now available with Schuko (EU), Belgian,
French, US and other types of sockets and in various configurations,
with 6, 8, 10 even 15 sockets per block.
For Europe, there is a further option of a high current On/Off
switch, mounted at the input end of the block (on the 6-way blocks
at present), which essentially switches off power to all the output
sockets.
For the Surge-Protected versions, one (or two) sockets do not
have Non-Intrusive Filtering, as this can lead to sonic degradation
with certain amplifiers.
The blocks up to 6-way are fitted with 10 Amp IEC sockets, while
the 8, 10 and 15-way blocks are fitted with 16 Amp IEC sockets.
Furthermore, the chassis are made from extruded Aluminium and
as such, the case work is shielded and hence helps to prevent
50 Hz (or 60 Hz) mains getting into other cables nearby, while
at the same time, reducing radio (and other mains borne) interference.
The current line up is:
6-way:
MD06 Mk3 EU NIF (unswitched)
MD06 Mk3 EU NIF (switched)
MD06 Mk3 EU/SP NIF (unswitched)
MD06 Mk3 EU/SP NIF (switched)
8 and 10 way:
MD08 Mk3 EU/SP NIF (unswitched)
MD10 Mk3 EU/SP NIF (unswitched)
-------------------------------------
Please note that no mains cable is supplied with these
blocks - this is so that you can purchase the correct length of
cable to go between your wall socket and the position of the Mains
Block.
We have pre-terminated lengths of both LoRad
1.5 and 2.5, factory fitted with a UK 13 Amp plug and a suitable
IEC connector, in lengths of 1m, 1.5m, 2m and 4m. Or you can buy
the LoRad 1.5 or LoRad 2.5 cable "off the drum" and make up
your own bespoke length.
|